瀏覽:64次 2020/06/03
做好鋼筋彎曲試驗機的預防工作
俗話說:“安全與效率至上,事故與損失并存”,因此鋼筋彎曲試驗機的事故預防工作不僅是確保安全的手段,而且是確保企業效益的手段。
1.檢查鋼筋彎曲試驗機的機械性能是否良好,工作臺和彎曲機工作臺應保持水平; 并準備各種心軸工具塊。
2.根據加工后的鋼筋直徑和直徑,安裝心軸,成型軸,鐵保持軸或可變保持架。
3. Check the mandrel, the stopper and the turntable should be free of damage and cracks, the protective cover should be fastened reliably, and the operation can only be confirmed after the empty machine is running.
4. During operation, insert the bent end of the steel bar into the gap provided by the turntable, and fix the other end against the fuselage and press it by hand. Check the fixation of the fuselage and make sure it is on the side blocking the steel bar before it can be started.
5. It is strictly forbidden to change the mandrel, change the angle and adjust the speed during the operation, and do not add oil or remove it.
2.根據加工后的鋼筋直徑和折彎機的要求,安裝心軸,成型軸,鐵固定軸或可變固定架。心軸的直徑應為鋼筋直徑的3倍。
7.彎曲硬度或低合金鋼筋時,應根據機械銘牌更改最大極限直徑,并更換相應的心軸。
8.嚴禁在彎曲的鋼筋半徑范圍內以及未固定機身的一側站立。 彎曲的半成品應整齊堆放,鉤子不得朝上。
只有對鋼筋彎曲試驗機采取預防措施,才能確保使用過程中的安全性。 希望大家不要違反規定。